Select the audio devices that make up aggregate device by clicking the appropriate box in the Use column.Click the plus ( +) in bottom left corner to create an aggregate device.If you want to use multiple external hardware devices at the same time, create an aggregate device in an aggregate device, all of the aggregated devices appear as separate channels of a single virtual aggregate device.įor example, to send audio to both Kyma and to another device (for example, you might want to route audio from a DAW through Kyma and, at the same time, send the audio to the audio interface attached to your computer), do the following: Some audio applications can only work with a single audio source or destination. More than one hardware input or output: macOS For best results, select the same sample rate for both the Pacamara and the audio software that will be working with the Pacamara’s audio stream (so the host does not have to re-sample).Select the desired sample rate from the drop down menu.Launch Audio MIDI Setup (found in the Utilities folder of the Applications folder).The sample rate of the Pacamara is initially set to 44.1 kHz on macOS. Kyma will restart the Pacamara the selected number of audio channels will be available after the restart.Ĭonfiguring the Pacamara virtual audio interface: macOS Use the drop-down menus in the Pacamara Configuration window to select the number of Host USB audio input and output channels and then click the Apply button. To set the number of audio input and output channels, select Pacamara from the Configure dropdown menu at the lower left of the DSP Status window (see below). To set the sample rate of the Pacamara, use the computer’s audio control panel app (see specific instructions for your computer, below). Configuring the Pacamara virtual audio interface Audio routing, recording, synthesis and processing software on the computer can now receive audio inputs from the Pacamara and/or send audio to the Pacamara for processing. On the computer, the Pacamara appears as an audio interface named “Pacamara”. (An alternative approach to integrating the Pacamara into your studio or live performance rig is to use a digital mixer as the audio interface for the Pacamara). Then, using the DSP Status window in Kyma, select Host USB as the source and destination of audio and/or MIDI data.įrom the point of view of applications running on the computer, the Pacamara appears as an audio and MIDI device. To route audio and/or MIDI data to your computer, connect the Pacamara USB-C port to a USB port on your computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |